Installing The Gas Spring Pin - MINN KOTA ULTREX Installation Instructions Manual

5
ITEM(S) NEEDED
#4 x 6
j. Put a 1/4-20 x 3 1/2" Screw (Item #4) in each
of the drilled locations. The Screw should pass
through the Mount Plate and the boat deck.
k. Place a Flat Washer (Item #5) and then a Nylock
Nut (Item #6) at the end of each screw as shown
and secure. Make sure all hardware is secure.
NOTE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may
help prevent seizing.

Installing the Gas Spring Pin

1
a. Position the motor to the stowed position with
the Pull Grip and Cable to disengage the latch bar,
allowing the motor to fold into a flat position.
b. Once in the stowed or flat position, the Gas
Spring Pin and Spacers can be installed.
©2016 Johnson Outdoors Marine Electronics, Inc.
#5 x 6 #6 x 6
INSTALLING THE GAS SPRING PIN
Screw
Flat Washer and
Nylock Nut
Deck
minnkotamotors.com | 9