Indexing The Motor - MINN KOTA ULTREX Installation Instructions Manual

INDEXING THE MOTOR

2
ITEM(S) NEEDED
#25 x 2
c. Locate the upper Gas Spring Pin (Item #27) and
Spacers (Item #26) in the bag assembly. Align the end
of the Gas Spring with the holes in the Outer Arm.
d. Install the Gas Spring Pin through the Outer Arm,
then through a Spacer, the end of the Gas Spring
Cylinder and another Spacer.
NOTE:
Spacers are placed on each side of
the Gas Spring on the inside of the Outer
Arm. Phillips Screws have a pre-applied
thread locker. Do not apply additional thread-
locker to them as it may prevent future
removal.
e. Install one Phillips Screw (Item #25) on each end
of the Gas Spring Pin and secure with two #3
Phillips screwdrivers.
f. Tighten Phillips Screws until the heads are flush
with the Outer Arm.
Indexing the Motor
It is recommended to have the Pedal Control Sleeve Assembly pointing inboard. If the Pedal Control Sleeve Assembly points
outboard, please see Orientate the Pedal Control Sleeve Assembly for a Starboard Mount. Use the following instructions to index
the motor if the Pedal Control Sleeve Assembly is already mounted inboard.
Once installed, the system is properly indexed when the motor is deployed and the head of the motor and lower unit align with
the centerline or keel of the boat at the same time the top of the Foot Pedal is parallel to the deck of the boat.
Inboard
Keel
10 | minnkotamotors.com
#26 x 2
#27 x 1
Control Head
Pedal Control
Sleeve Assembly
Deck of Boat
Phillips Screw
Gas Spring Pin
Spacer
Outer Arm
Outer Arm
Gas Spring
Spacer
Cylinder
Phillips Screw
Outboard
Deck of Boat
Keel
Gas Spring
Cylinder
Outer Arm
Spacer
Gas Spring
Spacer
Outer Arm
Phillips Screw
Pedal Control
Sleeve Assembly
©2016 Johnson Outdoors Marine Electronics, Inc.