MINN KOTA ULTREX Installation Instructions Manual page 14

INDEXING THE MOTOR
8
k. Reconfirm that the Steering Cables are tight
and then carefully thread the Steering Motor
Connection Wire through the top of the Wrap
Drum Cover. The male plug comes from the Cable
Anchor through the opening at the bottom of the
Wrap Drum Cover. The wire with the female plug
that runs out the top of the Cable Gear should
also be pulled through the opening at the bottom
of the Wrap Drum Cover.
CAUTION
Take care not to pinch the Steering Motor Connection
Wire while the Wrap Drum is set into place.
9
l. Place the Wrap Drum Cover down on top of the
Cable Anchor and align the screw holes on it with
the screw holes on the Cable Anchor. Make sure
the Wrap Drum Cover is nested securely on top of
the Steering Module and that the wires pass out
the top of the Wrap Drum Housing. Secure the
Wrap Drum Housing in place with the two screws
that were originally removed using a #1 Phillips
screwdriver. Tighten to 6 in-lbs.
10
m. Reconnect the Steering Motor Connection Plug
and push it into the Wrap Drum Cover.
CAUTION
Wires and plug must not touch moving parts. Wires may
be damaged if caught in moving parts.
n. Orientate the wires connecting the Steering
Motor Connection Plug as noted so that the wires
do not touch moving parts.
o. Replace the Connector Cover.
14 | minnkotamotors.com
Wrap Drum Cover
Cable Anchor
Screws
Wrap Drum Cover
Wires
Steering Motor
Connection Plug
Wires
Wrap Drum Cover
Steering Motor
Connection Wire
Steering
Module
©2016 Johnson Outdoors Marine Electronics, Inc.