MINN KOTA ULTREX Installation Instructions Manual page 25

1
ITEM(S) NEEDED
#24 x 1
a. Place the motor in the stowed position.
b. Locate the Universal Sonar and i-Pilot Link
Cable Connection, if equipped, at the base of the
Control Head.
NOTE:
If only one connection is present
below the Control Head, it is to connect
Universal Sonar.
Not following the recommended wire routing for the Universal Sonar and i-Pilot Link cables, if equipped, may cause damage
to the product and void your product warranty. Routing the cables in any way other than directed may cause damage to the
cables by being pinched or severed.
Do not over tighten the cable ties as it may damage the wires.
2
c. Locate the Universal Sonar Extension Cable
(Item #24) and connect it to the respective plug
below the Control Head. For more details on
connecting the Universal Sonar Extension Cable,
please see the Connecting Universal Sonar
section of this manual.
NOTE:
If your motor is equipped with
i-Pilot Link, a long cord with a plug will
already be factory installed and comes
out the bottom of the Control Head.
©2016 Johnson Outdoors Marine Electronics, Inc.
ROUTING UNIvERSAL SONAR & -PILOT LINK CABLES
Control Head
Universal
Sonar
CAUTION
CAUTION
Universal
Sonar
i
Coil
Cord
Universal Sonar
Extension Cable
Pedal Control
Sleeve Assembly
minnkotamotors.com | 25
i-Pilot Link Cable
Connection
i-Pilot Link Cable
Connection