Installing The Prop - MINN KOTA ULTREX Installation Instructions Manual

Installing the Prop

1
ITEM(S) NEEDED
#7 x 1
CAUTION
Disconnect the motor from the battery before beginning
any prop work.
a. Take the Drive Pin (Item #10) and slide it through
the Hole in the Armature Shaft. Position the
Drive Pin horizontal by grasping the Armature
Shaft and rotating it with the Drive Pin in place.
b. Align the Propeller (Item #7) so it is also
horizontal and parallel with the Drive Pin. Slide
the Propeller onto the Armature Shaft and Drive
Pin until it is seated against the lower unit.
c. Install the Prop Washer (Item #8) and the Prop
Nut (Item #9) onto the end of the Armature
Shaft.
d. Holding the end of the Armature Shaft with a Flat
Blade Screwdriver, tighten the Prop Nut with a
9/16" Open End Wrench.
e. Tighten the Prop Nut 1/4 turn past snug to
25-35 in-lbs.
CAUTION
Do not over tighten as this can damage the prop.
©2016 Johnson Outdoors Marine Electronics, Inc.
#9 x 1
#8 x 1
#10 x 1
1a
Drive Pin
Prop Washer
1b
1d
Prop Nut
Prop Washer
Propeller
INSTALLING THE PROP
Armature Shaft
Propeller
Prop Nut
Propeller
Drive Pin
minnkotamotors.com | 27