Mounting The Foot Pedal - MINN KOTA ULTREX Installation Instructions Manual

MOUNTING THE FOOT PEDAL

4
h. Replace the Bottom Bumper on the Aluminum
Rod, opposite from the threads.
i. Thread the Aluminum Rod into the Stabilizer
Bracket with the Bottom Bumper towards the
boat deck.
j. Adjust the Aluminum Rod up or down in the
Stabilizer Bracket so that the Bottom Bumper
just touches the support surface.
CAUTION
Adjusting the Aluminum Rod too tightly removes the end
play needed for proper latch pin engagement and doing
so could prevent the mount from fully latching in the
stowed position. Improper latching may cause damage.
If installed correctly, the tip of the Aluminum Rod should
lift off of the boat deck about 1/4" without the mount
unlatching.
5
k. Once in the correct position, tighten the Jam Nut
upwards against the Stabilizer Bracket. This will
prevent the Aluminum Rod from turning.
l. Install the Top Bumper if there are threads
exposed on the Aluminum Rod above the
Stabilizer Bracket.
Mounting the Foot Pedal
We recommend securing the Foot Pedal to the boat deck to
prevent it from being damaged during transport and to make
motor operation more efficient. It is recommended to use
the Mounting Holes on the Foot Pedal for a secure mount.
The Foot Pedal has three Mounting Holes. One Mounting
Hole is located under the Heel End of the Foot Pedal. The
other two are located under the Toe End of the Foot Pedal.
We recommend using a 1/8" or 3/16" diameter screw and
only tighten enough to slightly compress the Bumper Pads
underneath the Foot Pedal.
22 | minnkotamotors.com
Stabilizer Bracket
Stabilizer
Bracket
Heel End
Mounting Holes
Jam Nut
Aluminum Rod
Bottom Bumper
Top Bumper
Jam Nut
Toe End
Mounting Holes
Bumper Pad
©2016 Johnson Outdoors Marine Electronics, Inc.