MINN KOTA ULTREX Installation Instructions Manual page 16

ORIENTATE THE PEDAL CONTROL SLEEvE ASSEMBLY FOR A STARBOARD MOUNT
2
c. Remove the Connector Cover from the Wrap
Drum Cover using a 1/8" wide Flat Screwdriver
to release it. Release it by pressing the flat part of
the screwdriver in the slot closest to the center of
the Connector Cover and prying upwards.
d. Once the Connector Cover is removed,
disconnect the Steering Motor Connection Plug
that is visible.
2e
Steering Motor Connection Plug
Wrap Drum
Cover
3
e. Remove the two screws that hold the Wrap Drum
Cover in place with a #1 Phillips Screwdriver.
Once removed, lift the Wrap Drum Cover away
from the Steering Module.
CAUTION
Be careful to not damage the Steering Motor Connection
Plug ends and wires.
4
f. The Cable Tension Screw that holds tension on
the Steering Cables is located under the base of
the Toe End of the Foot Pedal. This screw can be
loosened just enough so that the Steering Cables
can be pinched together between the Cable Anchor
and Wrap Drum. Use a #3 Phillips screwdriver to
loosen this screw. Turning the screw approximately
8 turns counterclockwise should provide enough
slack in the cables to adjust. Keep track of the
number of turns the screw is unscrewed so it can be
re-tightened accordingly later.
CAUTION
Over loosening the Cable Tension Screw may cause the
cables to disengage from the Wrap Drum.
16 | minnkotamotors.com
2d
Connector
Cover
NOTE: Please note the orientation and routing of
the plug and wires for re-installation.
Steering
Module
Steering Motor
Connection Plug
Wrap Drum
Cover
Toe End of
Foot Pedal
Cable Tension
Screw
NOTE: The cables are fed through the Cable Anchor
and wound around the Wrap Drum. The right cable
begins winding on the Wrap drum from the top down.
The left cable begins winding on the Wrap drum from
the bottom up.
Flat
Screwdriver
Connector
Wrap Drum
Cover
Cover
Screws
Steering Motor
Connection Plug
©2016 Johnson Outdoors Marine Electronics, Inc.