Scope Subsystem; Introduction - HP 1652B Programming Reference Manual

SCOPe Subsystem

Introduction

HP 16528/16538
Programming Reference
The SCOPe subsystem provides access to the commands and the
oscilloscope subsystem commands that control the basic operation of the
oscilloscope. At the SCOPe subsystem level is a command that turns the
oscilloscope on or off (SMODe) and the AUToscale command.
Additionally, the following subsystems are a part of the SCOPe subsystem.
Each is explained in a separate chapter.
l
l
l
l
l
l
Not all scope-related functions can be duplicated with programming
instructions. If you are unable to get a desired configuration strictly
through programming instruction, try the following steps:
1.
Manually configure the HP 1652B/53B through the front panel.
2. Save configuration to a disk (through the front panel or through the
Now you can use the command
configuration.
SCOPe Subsystem Syntax
Figure 21-1.
(chapter 22)
(chapter 23)
(chapter 24)
(chapter 25)
(chapter 27)
instruction).
MMEM: LOAD
to load in the desired
Diagram
SCOPe Subsystem
21-1