Table of Contents
Advertisement
MEASure
MEASure
Command Syntax:
Example:
Note d
MEASure Subsystem
27-4
The MEASure selector is used as part of a compound command header
to access the settings found in oscilloscope's Measure menu. It always
follows the SCOPe selector because it selects a branch below the SCOPe
level in the command tree.
OUTPUT XXX; ":SCOPE:MEASURE:SOURCE
All queries in this subsystem return the measurement results of the last
channel specified by the SOURce command. If you want measurement
results from the other channel, you must use the SOURce command
before using any of the queries.
selector
HP 16526/l 6538
Programming Reference
Advertisement
Table of Contents
