Table of Contents
Advertisement
command
The AUToscale command causes the current analyzer (machine) to
autoscale if the current machine is a timing analyzer. If the current
machine is not a timing analyzer, the AUToscale command is ignored.
execution of subsequent commands while the logic analyzer operations
initiated by the Overlapped Command are still in progress. Command
overlapping can be avoided by using the *OPC and *WAI commands in
conjunction with AUToscale (see chapter 5, "Common Commands.")
When the AUToscale command is issued, existing timing analyzer
Note d
configurations are erased and the other analyzer is turned off.
Command Syntax:
OUTPUT XXX;":MACHINEl:AUTOSCALE"
Example:
HP 16528/1663B
Progmmming Reference
Advertisement
Table of Contents
