Table of Contents
Advertisement
STOP
Note d
Command Syntax:
Example:
HP 16528/l 6538
Programming Reference
The STOP command is a run control command that stops the logic
analyzer.
The STOP command is on the same level in the command tree
as SYSTem; therefore, it is not preceded by :SYSTem.
The STOP command is an Overlapped Command. An Overlapped
Command is a command that allows execution of subsequent commands
while the device operations initiated by the Overlapped Command are still
in progress.
OUTPUT m":STOP
STOP
command
System Commands
6-39
Advertisement
Table of Contents
