Table of Contents
Advertisement
[ROUTe:]CLOSe
1
SCPI Command
Reference
[ROUTe:]
Subsystem Syntax
CLOSe
Parameters
42 Command Reference
This section describes the Standard Commands for Programmable Instruments
(SCPI) commands for the RF Multiplexer. Commands are listed alphabetically by
subsystem and also within each subsystem. Command guides are printed in the top
margin of each page. The left guide indicates the first command listed on that page.
The right guide indicates the last command listed on that page. Where only a single
command appears on a page, the left and right guides will be the same.
The ROUTe command subsystem controls switching operations for the RF
Multiplexer in a switchbox.
[ROUTe:]
CLOSe <channel_list>
CLOSe? <channel_list>
OPEN? <channel_list>
[ROUTe:]CLOSe <channel_list >closes the RF Multiplexer channels specified by
channel_list. channel_list has the form (@ccmmnn) where cc = card number
(01-99), mm = module number (00-02), and nn = channel number (00-03, 10-13,
20-23, 30-33, 40-43, or 50-53).
Parameter
Parameter
Name
Type
channel_list numeric
numeric
numeric
Range of Values
01-99
00-02
00-03 |10-13 |20-23 |30-33 |40-43 |50-53
[ROUTe:]CLOSe
Item
card (cc)
module (mm)
channel (nn)
Chapter 4
Advertisement
Table of Contents
