System Commands
6-36
The SYStem:SETup command configures the logic analyzer module as
defined by the block data sent by the controller.
The SYStem:SETup query returns a block of data that contains the
current configuration to the controller.
There are three data sections which are always returned and a fourth
header when the oscilloscope is on and has acquired and stored waveform
data. These are the strings which would be included in the section header:
"1650 RS232"
"1650 DISP "
"1650 DISP2"
"SCOPECNF "
Additionally, the following sections may also be included, depending on
what's loaded:
"SYMBOLS A -
"SYMBOLS B "
"SPA DATA A"
"SPA DATA 8"
l
"INVASH A "
l
"INVASM B "
"COMPARE
command/query
HP 16528/1653B
Programming Reference