Table of Contents
Advertisement
DATA
Note #b
Note '$
HP 16628/1653B
Programming Reference
The DATA command allows you to send and receive acquired data to and
from a controller in block form. This helps saving block data for:
Re-loading to the logic analyzer
l
Processing data later
l
Processing data in the controller.
l
The format and length of block data depends on the instruction being
used and the configuration of the instrument. This section describes each
part of the block data as it will appear when used by the DATA
instruction. The beginning byte number, the length in bytes, and a short
description is given for each part of the block data. This is intended to be
used primarily for processing of data in the controller.
Do not change the block data in the controller if you intend to send the
block data back into the logic analyzer for later processing. Changes
made to the block data in the controller could have unpredictable results
when sent back to the logic analyer.
The SYSTem:DATA query returns the block data.
The data sent by the SYSTem:DATA query reflects the configuration of
the machines when the last run was performed. Any changes made since
then through either front-panel operations or programming commands do
not affect the stored configuration.
DATA
command/query
System Commands
6 5
Advertisement
Table of Contents
