Chapter 7: Operation
Click Reboot. When the "
3
message is displayed, click OK.
4
The unit will now reboot. The unit should now start up in normal mode but with the CSPs
zeroized. If the unit fails to recover, refer to
Rebooting the unit
Use this option to reboot the unit from the Recovery Options page
Procedure:
•
Click Reboot.
•
When the "
Are you sure you want to REBOOT this unit?
click OK. The unit will now reboot. The unit should now start up in normal operational mode. If
the unit fails to start up, refer to
Are you sure you want to REBOOT this unit?
Testing link end hardware
Testing link end hardware
Page
7-51
on page 8-2.
(Figure
133).
" message is displayed,
on page 8-2.
Recovery mode
"