Table of Contents
Advertisement
Chapter 7: Operation
3
Click OK. The reset confirmation page is displayed:
4
Click Reboot. When the "
is displayed, click OK.
5
The unit will now reboot. The unit should now start up in normal mode but with the IP and
Ethernet configuration reset to factory defaults. If the unit fails to recover, refer to
end hardware
on page 8-2.
Erasing configuration
Use this option to erase the entire configuration of the unit from the Recovery Options page
(Figure
133).
Are you sure you want to REBOOT this unit?
Page
7-48
Recovery mode
" message
Testing link
Advertisement
Table of Contents
