Table of Contents
Advertisement
Chapter 5: Installation
Installing an Aux Ethernet interface
In more advanced configurations, there may be a copper Cat5e Ethernet interface connected to the
Aux port of the ODU. Refer to
Adapt the installation procedures in this chapter as appropriate for the Aux interface, noting the
following differences:
•
At the remote end of the Aux drop cable, use an appropriate termination for the connected
device (for example, a video camera or wireless access point).
•
If the connected device is outdoors, not in the equipment building or cabinet, adapt the
grounding instructions as appropriate.
•
Ground the top LPUs and surge protector to the same point on the ODU
Typical deployment
on page
Page
5-32
Installing an Aux Ethernet interface
3-2
for a diagram of this configuration.
(Figure
57).
Advertisement
Table of Contents
