Table of Contents
Advertisement
Chapter 5: Installation
Installing the AC+DC Enhanced Power Injector
Follow this procedure to install the AC+DC Enhanced Power Injector (Cambium part number
C000065L002):
1
Mount the AC+DC power injector by screwing it to a vertical or horizontal surface using the
four screw holes (circled):
2
Form a drip loop on the PSU end of the LPU to PSU drop cable. The drip loop ensures that
any moisture that runs down the cable into the cabinet or enclosure cannot enter the PSU.
3
(a) Undo the retaining screw, hinge back the cover and plug the drop cable into the port. (b)
Close the cover and secure with the screw. (c) When the system is ready for network
connection, connect the network Cat5e cable to the LAN port of the PSU:
(a)
(b) and (c)
Page
5-22
Installing the PSU
Advertisement
Table of Contents
