Table of Contents
Advertisement
Chapter 5: Installation
Disconnect the drop cable from the LPU or ODU
Use this procedure if it is necessary to remove an EMC strain relief cable gland and RJ45
connector from the ODU (as illustrated) or LPU.
1 (a) Remove the gland nut. Wiggle the drop cable to release the tension of the gland body.
When the tension in the gland body is released, a gap opens at the point show. Unscrew the
gland body.
(b) Use a small screwdriver to press the RJ45 locking tab, then remove the RJ45 connector.
(a)
Install the main drop cable
Warning
The metal screen of the drop cable is very sharp and may cause personal injury.
•
ALWAYS wear cut-resistant gloves (check the label to ensure they are cut
resistant).
•
ALWAYS wear protective eyewear.
•
ALWAYS use a rotary blade tool to strip the cable (DO NOT use a bladed knife).
Installing the copper Cat5e Ethernet interface
(b)
Page
5-15
Advertisement
Table of Contents
