Table of Contents
Advertisement
Chapter 5: Installation
Fitting the long cable gland
Optical SFP interface: Disassemble the long cable gland and thread its components over the LC
connector at the ODU end as shown below.
Copper Cat5e SFP interface: Disassemble the long cable gland and thread its components over the
RJ45 connector at the ODU end as shown below.
1
Disassemble the gland:
2
Thread each part onto the cable (the rubber bung is split):
3
Assemble the spring clip and the rubber bung (the clips go inside the ring):
Page
5-25
Installing an SFP Ethernet interface
Advertisement
Table of Contents
