Table of Contents
Advertisement
Chapter 6: Configuration and alignment
Graphical Install page
Menu option: Installation > Graphical Install
This is the second of two methods that may be used to monitor receive signal level during antenna
alignment.
Figure 104 Graphical Install page
Procedure:
•
Check that Wireless Link Status (top left) is "Up", "Registering", "Searching" or "Acquiring".
•
While slowly sweeping the antenna, monitor the trace of receive power over the last three
minutes.
•
Monitor the Receiver Power Bar (bottom right). Green signifies that the wireless link is up and
red signifies all other states.
•
Monitor the Wireless Install Metric (top right). This is the instantaneous receive power in
dBm + 110.
Note
To access the PDA version of the graphical installation tool, use this URL -
http://<ip-address>/pda.cgi. This link is only available to system administrators.
(Figure
104).
Page
6-92
Aligning antennas
Advertisement
Table of Contents
