Table of Contents
Advertisement
Chapter 7: Operation
Table 119 Recovery Options buttons
Button
Upgrade Software
Image
Reset IP & Ethernet
Configuration back to
factory defaults
Erase Configuration
Zeroize Critical
Security Parameters
Reboot
Upgrading software image
Use this option to restore a working software image from the Recovery Options page
Procedure:
1
Click Browse.
2
Navigate to the required software image. This may be the most recent image if software
corruption is suspected, or an older image if an incorrect image has just been loaded. Click on
the image and click Open.
3
Click Upgrade Software Image. The Confirmation page is displayed. Click Program Software
Image into Non-Volatile Memory. The Upgrade Progress Tracker page is displayed:
Purpose
Use this option to restore a working software version when software
corruption is suspected, or when an incorrect software image has been
loaded. Refer to
Upgrading software image
Use this option to restore the IP and Ethernet attributes to their defaults.
Refer to
Resetting IP & Ethernet configuration
Use this option to erase the entire configuration of the unit. Refer to
Erasing configuration
on page 7-48.
Use this option to reset encryption keys and the system administrator
password. Refer to
Zeroize Critical Security Parameters page
50.
Use this option to reboot the unit. Refer to
7-51.
Page
on page 7-46.
on page 7-47.
Rebooting the unit
7-46
Recovery mode
on page
7-
on page
(Figure
133).
Advertisement
Table of Contents
