Table of Contents
Advertisement
Chapter 6: Configuration and alignment
Table 93 Step 3: SNMP Trap Configuration attributes (for SNMPv1/2c)
Attribute
SNMP Trap Version
SNMP Enabled
Traps
SNMP Trap
Receiver Enabled
SNMP Trap Internet
Address
SNMP Trap Port
Number
Confirm SNMP Configuration (for SNMPv1/2c)
Menu option: Management > SNMP. Part of the SNMP Wizard
Use this page to review and confirm the updated SNMPv1/2c configuration of the unit.
Figure 93 Confirm SNMP Configuration page (for SNMPv1/2c) (top and bottom of page shown)
Procedure:
•
To ensure that the changes take effect, click Confirm SNMP Configuration and Reboot. The unit
reboots and the changes take effect.
Meaning
Select the SNMP protocol version to use for SNMP traps: v1 or v2c.
Select the events that will generate SNMP traps.
Disabled: SNMP traps are not sent to the corresponding SNMP Trap
Receiver (1 or 2).
Enabled: SNMP traps are sent to the corresponding SNMP Trap Receiver
(1 or 2).
The IPv4 or IPv6 Address of the SNMP server (trap receiver). This is
normally the network management system, but it may be a separate trap
receiver.
The server port at which SNMP traps are received.
Page
SNMP pages (for SNMPv1/2c)
(Figure
93).
6-74
Advertisement
Table of Contents
