Table of Contents
Advertisement
Chapter 7: Operation
4
When the Software Upgrade Complete page is displayed, check that the correct image has
been downloaded:
Click Reboot Wireless Unit. When the "
5
6
The unit will now reboot and restart in normal operational mode, and the link should recover.
If the unit or link fails to recover, refer to
Resetting IP & Ethernet configuration
Use this option to reset IPv4, IPv6 and Ethernet configuration back to defaults from the Recovery
Options page
(Figure
133).
Note
This procedure resets the IP Version attribute to IPv4. It also resets the IPv6
configuration.
Procedure:
1
Click Reset IP & Ethernet Configuration back to factory defaults. The reset pop up box is
displayed:
2
Record the IP address, as it will be needed to log into the unit after recovery.
" message is displayed, click OK.
Are you sure?
Testing link end hardware
Page
7-47
Recovery mode
on page 8-2.
Advertisement
Table of Contents
