Supported Diagnostic Alarms; Enabling Snmp - Cambium Networks PTP 650 Series User Manual

Chapter 3: System planning

Supported diagnostic alarms

PTP 650 supports the diagnostic alarms listed in
The web-based interface may be used to enable or disable generation of each supported SNMP
notification or diagnostic alarm.

Enabling SNMP

Enable the SNMP interface for use by configuring the following attributes in the SNMP
Configuration page:
•
SNMP State (default disabled)
•
SNMP Version (default SNMPv1/2c)
•
SNMP Port Number (default 161)
Table 101.
Page
3-32
Network management planning