Shutting Down An Aggregate Interface; Restoring The Default Settings For An Aggregate Interface; Configuring Load Sharing For Link Aggregation Groups - HP FlexFabric 12900 Series Configuration Manual

Shutting down an aggregate interface

Make sure no member port in an aggregation group is configured with the loopback command when
you shut down the aggregate interface. Similarly, a port configured with the loopback command cannot
be assigned to an aggregate interface already shut down. For more information about the loopback
command, see Layer 2—LAN Switching Command Reference.
Shutting down or bringing up an aggregate interface affects the aggregation state and link state of ports
in the corresponding aggregation group in the following ways:
When an aggregate interface is shut down, all Selected ports in the corresponding aggregation
•
group become unselected and their link state becomes down.
• When an aggregate interface is brought up, the aggregation state of ports in the corresponding
aggregation group is recalculated.
To shut down an aggregate interface:
Step
1. Enter system view.
2. Enter Layer 2 aggregate
interface view.
3. Shut down the aggregate
interface.

Restoring the default settings for an aggregate interface

You can return all configurations on an aggregate interface to default settings.
To restore the default settings for an aggregate interface:
Step
1. Enter system view.
2. Enter Layer 2 aggregate interface view.
3. Restore the default settings for the aggregate
interface.
Configuring load sharing for link aggregation
groups
This section explains how to configure load sharing modes for link aggregation groups and how to
enable local-first load sharing for link aggregation.
Command
system-view
interface bridge-aggregation
interface-number
shutdown
Command
system-view
interface bridge-aggregation interface-number
default
50
Remarks
N/A
N/A
By default, aggregate interfaces
are up.