GE G60 Instruction Manual page 96

4.2 FACEPLATE INTERFACE
e) ENTERING INITIAL PASSWORDS
To enter the initial Setting (or Command) Password, proceed as follows:
1. Press the MENU key until the
the display.
2. Press the MESSAGE RIGHT key until the
3. Press the MESSAGE DOWN key until the
4
play.
SETTINGS
SETTINGS
PRODUCT SETUP
4. After the
CHANGE...PASSWORD
selection to "Yes".
5. Press the ENTER key and the display will prompt you to
6. Type in a numerical password (up to 10 characters) and press the ENTER key.
7. When the
VERIFY NEW PASSWORD
CHANGE SETTING
PASSWORD: No
CHANGE SETTING
PASSWORD: Yes
8. When the
NEW PASSWORD HAS BEEN STORED
active.
f) CHANGING EXISTING PASSWORD
To change an existing password, follow the instructions in the previous section with the following exception. A message will
prompt you to type in the existing password (for each security level) before a new password can be entered.
In the event that a password has been lost (forgotten), submit the corresponding encrypted password from the
menu to the Factory for decoding.
SECURITY
g) INVALID PASSWORD ENTRY
In the event that an incorrect Command or Setting password has been entered via the faceplate interface three times within
a three-minute time span, the
Settings or Command access via the faceplate interface for the next ten minutes. The
flash message will appear upon activation of the ten minute timeout or any other time a user attempts any
FOR 10 MIN!
change to the defined tier during the ten minute timeout. The
"Off" after the expiration of the ten-minute timeout.
4-12
header flashes momentarily and the
SETTINGS
ACCESS LEVEL
CHANGE SETTING
PASSWORD
SECURITY
message appears on the display, press the VALUE UP or DOWN key to change the
is displayed, re-type in the same password and press ENTER.
ENTER NEW
PASSWORD: ##########
message appears, your new Setting (or Command) Password will be
FlexLogic™ operand will be set to "On" and the G60 will not allow
LOCAL ACCESS DENIED
G60 Generator Management Relay
PRODUCT SETUP
message appears on the display.
(or )
COMMAND PASSWORD
ACCESS LEVEL:
Restricted
CHANGE COMMAND
PASSWORD: No
CHANGE SETTING
PASSWORD: No
ENCRYPTED COMMAND
PASSWORD: ---------
ENCRYPTED SETTING
PASSWORD: ---------
.
ENTER NEW PASSWORD
VERIFY NEW
PASSWORD: ##########
NEW PASSWORD
HAS BEEN STORED
TOO MANY ATTEMPTS – BLOCKED
FlexLogic™ operand will be set to
LOCAL ACCESS DENIED
4 HUMAN INTERFACES
message appears on
message appears on the dis-
PASSWORD
GE Multilin