Connecting To The G60 Relay - GE G60 Instruction Manual
Ur series generator management relay
Hide thumbs
Also See for G60:
- Instruction manual (780 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (722 pages)
Table of Contents
Advertisement
1 GETTING STARTED
1.
Open the Display Properties window through the Site List tree as shown below:
2.
The Display Properties window will open with a status indicator on the lower left of the EnerVista UR Setup window.
3.
If the status indicator is red, verify that the Ethernet network cable is properly connected to the Ethernet port on the
back of the relay and that the relay has been properly setup for communications (steps A and B earlier).
If a relay icon appears in place of the status indicator, than a report (such as an oscillography or event record) is open.
Close the report to re-display the green status indicator.
4.
The Display Properties settings can now be edited, printed, or changed according to user specifications.
Refer to Chapter 4 in this manual and the EnerVista UR Setup Help File for more information about the
using the EnerVista UR Setup software interface.
NOTE
GE Multilin
Expand the Site List by double-clicking
or by selecting the [+] box
Communications Status Indicator
Green LED = OK, Red LED = No Communications
UR icon = report open
G60 Generator Management Relay
1.3 ENERVISTA UR SETUP SOFTWARE
1.3.5 CONNECTING TO THE G60 RELAY
842743A1.CDR
1
1-15
Advertisement
Table of Contents
