Connecting A Pc To -X51 Via Rs 232 - Siemens SINAMICS G180 Installation And Operating Instructions Manual

Operation
8.4 Controlling the external connections of the inverter
Connect the USB- port -X50B with a USBport on your notebook. Use a standard cable that is
not longer than 3 m.
Personal injuries caused by a defective unit or inverter
Read the connection instructions given in section "Electrical isolation of USB interfaces"
(Page 149) and "Safe isolation in accordance with EN 61800-5-1" (Page 145).
The version of the installed IMS software must be "Z24" or higher. The USB connection
feature is not available in earlier versions.
In the menu "Options/drivers" select theUSB driver.
8.4.8

Connecting a PC to -X51 via RS 232

Figure 8-22
NOTICE
Damage to the inverter electronics or the PC.
The pins of socket -X51 are assigned signals other than those shown here. Do not use a
standard cable that is completely assigned, as otherwise the inverter electronics or the PC
could be damaged. Only use cables where only the required pins are assigned.
Further information about connecting PC and inverter, etc. can be found in the help in the
software "IMS".
● Connect the cable shield at both sides on the Sub-D housing.
154
CAUTION
PC at -X51 via RS 232
Installation and Operating Instructions SINAMICS G180
Operating Instructions, 02/2019, 4BS0751-007