Fresenius Medical Care 2008T Troubleshooting Manual page 735

Yes Bic Press between negative 50 and positive 30! See part C.
No Bic Press is NOT between negative 50 and positive 30! Leaving the door OPEN, see procedure
number V104SC-
C) Close the bibag Connector door!
RETURN TO RINSE!
D)
E) Call debug screen 15. If debug does not appear press 'Esc' then call screen 15.
Bic Press
F) may fluctuate but MUST, at least once,
achieve more than POSITIVE 400. It may exceed 800 and
this is okay!
G) Watch Bic Press for one (1) minute OR until if it achieves
at least 400. TWO (2) possible scenarios:
1) IF NEVER achieves POSITIVE 400: Proceed to
2) IF achieves POSITIVE 400 or more at least once: See part A below:
A) Press 'Esc' to return to the main RINSE screen. THREE (3) possible scenarios:
1) IF (and ONLY if) the [Remaining Time] window is NOT 'blinking': See part B.
2) IF (and ONLY if) [Remaining Time] is 'blinking' AND the "V104/108 Stuck Closed"
banner is up: Proceed to
3) IF [Remaining Time] is 'blinking' AND the "V104/108 Stuck Closed" banner is NOT
up: Address whatever alarm banner is showing.
B) The first part of clearing "V104/108 Stuck Closed", is successful. Now, when rinse finishes, Bic
Press must significantly decrease through Valves #104 and #108.
C) Watch carefully until if [Remaining Time] = 0:00. Does "V104/108 Stuck Closed" reappear?
Yes
No V104/108 Stuck Closed" NEVER reappears! When RINSE finishes return to Dialysis
Program ("Select Program" →.'Dialysis' → 'Enter'). TWO (2) possible scenarios:
1)
2)
page 732
1.0.22 ( ).
page 739
"V104/108 Stuck Closed" reappears! Proceed to
V104SC- 2.0.3.
IF (and ONLY if) "V104/108 Stuck Closed" reappears: Proceed to
438
, procedure number
IF V104/108 Stuck Closed" does NOT reappear: The alarm has been cleared!
Possibly the blue connector was not inserted properly into its rinse port when
last rinsed.
2008T Troubleshooting Guide
P/N 490292 Rev. A
page 736
, procedure number V104SC- 2.0.0.
, procedure number V104SC- 2.0.3.
page 739
CO- 14.0.0.
, procedure number
page
Page 731