Xconfiguration Video Selfview Oncall Duration; Xconfiguration Video Selfview Oncall Mode - Cisco TelePresence DX70 Reference Manual

Cisco TelePresence DX70 and DX80

Introduction

xConfiguration Video Selfview OnCall Mode

This setting is used to switch on self-view for a short while when setting up a call. The Video
Selfview OnCall Duration setting determines for how long it remains on. This applies when self-
view in general is switched off.
Requires user role: ADMIN, INTEGRATOR
Default value: On
USAGE:
xConfiguration Video Selfview OnCall Mode:
where
Mode
: Off/On
Off: Self-view is not shown automatically during call setup.
On: Self-view is shown automatically during call setup.

xConfiguration Video Selfview OnCall Duration

This setting only has an effect when the Video Selfview OnCall Mode setting is switched On. In
this case, the number of seconds set here determines for how long self-view is shown before it
is automatically switched off.
Requires user role: ADMIN, INTEGRATOR
Default value: 10
USAGE:
xConfiguration Video Selfview OnCall Duration:
where
Duration
: Integer (1..60)
Range: Choose for how long self-view remains on. The valid range is between 1 and 60
seconds.
D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration xConfiguration
Mode
Duration
xCommand
89
API Reference Guide
xStatus Appendices
Copyright © 2017 Cisco Systems, Inc. All rights reserved.