Xconfiguration Video Selfview Default Pipposition; Xconfiguration Video Selfview Oncall Mode; Xconfiguration Video Selfview Oncall Duration - Cisco TelePresence SX10 Reference Manual

Cisco TelePresence SX10

Introduction

xConfiguration Video Selfview Default PIPPosition

Define the position on screen of the small self-view picture-in-picture (PiP) after a call. The
setting only takes effect when self-view is switched on (see the Video Selfview Default Mode
setting) and fullscreen view is switched off (see the Video Selfview Default FullscreenMode
setting).
Requires user role: ADMIN
Default value: Current
USAGE:
xConfiguration Video Selfview Default PIPPosition:
where
PIPPosition
: Current/UpperLeft/UpperCenter/UpperRight/CenterLeft/CenterRight/
LowerLeft/LowerRight
Current: The position of the self-view PiP will be kept unchanged when leaving a call.
UpperLeft: The self-view PiP will appear in the upper left corner of the screen.
UpperCenter: The self-view PiP will appear in the upper center position.
UpperRight: The self-view PiP will appear in the upper right corner of the screen.
CenterLeft: The self-view PiP will appear in the center left position.
CentreRight: The self-view PiP will appear in the center right position.
LowerLeft: The self-view PiP will appear in the lower left corner of the screen.
LowerRight: The self-view PiP will appear in the lower right corner of the screen.
Cisco TelePresence SX10 API Reference Guide CE8.2, SEPTEMBER 2016.
D15333.07
About the API xConfiguration xConfiguration
PIPPosition
xCommand

xConfiguration Video Selfview OnCall Mode

This setting is used to switch on self-view for a short while when setting up a call. The Video
Selfview OnCall Duration setting determines for how long it remains on. This applies when
self-view in general is switched off.
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration Video Selfview OnCall Mode:
where
Mode
: Off/On
Off: self-view is not shown automatically during call setup.
On: self-view is shown automatically during call setup.

xConfiguration Video Selfview OnCall Duration

This setting only has an effect when the Video Selfview OnCall Mode setting is switched On. In
this case, the number of seconds set here determines for how long self-view is shown before it
is automatically switched off.
Requires user role: ADMIN
Default value: 10
USAGE:
xConfiguration Video Selfview OnCall Duration:
where
Duration
: Integer (1..60)
Range: Choose for how long self-view remains on. The valid range is between 1 and 60
seconds.
93
API Reference Guide
xStatus Appendices
Mode
Duration
Copyright © 2016 Cisco Systems, Inc. All rights reserved.