Peripherals Configuration; Xconfiguration Peripherals Profile Cameras; Xconfiguration Peripherals Profile Controlsystems; Xconfiguration Peripherals Profile Touchpanels - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80

Introduction

Peripherals configuration

xConfiguration Peripherals Profile Cameras

Define the number of cameras that are expected to be connected to the video system. This
information is used by the video system's diagnostics service. If the number of connected
cameras does not match this setting, the diagnostics service will report it as an inconsistency.
Requires user role: ADMIN, INTEGRATOR
Default value: Minimum1
USAGE:
xConfiguration Peripherals Profile Cameras:
where
: NotSet/Minimum1/0/1/2/3/4/5/6/7
Cameras
NotSet: No camera check is performed.
Minimum1: At least one camera should be connected to the video system.
0-7: Select the number of cameras that are expected to be connected to the video
system.
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API xConfiguration xConfiguration
Cameras
xCommand

xConfiguration Peripherals Profile ControlSystems

Define if a third-party control system, for example Crestron or AMX, is expected to be
connected to the video system. This information is used by the video system's diagnostics
service. If the number of connected control systems does not match this setting, the diagnos-
tics service will report it as an inconsistency. Note that only one third-party control system is
supported.
If set to 1, the control system must send heart beats to the video system using xCommand
Peripherals Pair and HeartBeat commands. Failing to do so will cause the in-room control
extensions to show a warning that the video system has lost connectivity to the control system.
Requires user role: ADMIN, INTEGRATOR
Default value: NotSet
USAGE:
xConfiguration Peripherals Profile ControlSystems:
where
: 1/NotSet
ControlSystems
1: One third-party control system should be connected to the video system.
NotSet: No check for a third-party control system is performed.

xConfiguration Peripherals Profile TouchPanels

Define the number of Cisco Touch controllers that are expected to be connected to the video
system. This information is used by the video system's diagnostics service. If the number of
connected Touch controllers does not match this setting, the diagnostics service will report it
as an inconsistency.
Requires user role: ADMIN, INTEGRATOR
Default value: Minimum1
USAGE:
xConfiguration Peripherals Profile TouchPanels:
where
: NotSet/Minimum1/0/1/2/3/4/5
TouchPanels
NotSet: No touch panel check is performed.
Minimum1: At least one Cisco Touch controller should be connected to the video
system.
0-5: Select the number of Touch controllers that are expected to be connected to the
video system. Note that only one Cisco Touch controller is officially supported.
70
API Reference Guide
xStatus Appendices
ControlSystems
TouchPanels
Copyright © 2017 Cisco Systems, Inc. All rights reserved.