Xcommand Camera Triggerautofocus; Cameras Commands; Xcommand Cameras Autofocus Diagnostics Start; Xcommand Cameras Autofocus Diagnostics Stop - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80

Introduction

xCommand Camera TriggerAutofocus

Trigger the auto-focus functionality. The camera must support auto-focus functionality. If the
camera is daisy chained, the CameraId is given by its place in the chain.
Requires user role: ADMIN, USER
USAGE:
xCommand Camera TriggerAutofocus CameraId:
where
: Integer (1..7)
CameraId
Select the camera to auto-focus.
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API xConfiguration
CameraId
xCommand xCommand

Cameras commands

xCommand Cameras AutoFocus Diagnostics Start

Start diagnostics on auto focus.
Requires user role: ADMIN, INTEGRATOR
USAGE:
xCommand Cameras AutoFocus Diagnostics Start CameraId:
where
: 1..7
CameraId
Select which camera to diagnose.

xCommand Cameras AutoFocus Diagnostics Stop

Stop diagnostics on auto focus.
Requires user role: ADMIN, INTEGRATOR
USAGE:
xCommand Cameras AutoFocus Diagnostics Stop CameraId:
where
: 1..7
CameraId
Select which camera to diagnose.

xCommand Cameras PresenterTrack ClearPosition

This setting applies only when using a Cisco TelePresence SX80 with a Precision 60 camera or
SpeakerTrack 60 camera.
Clear the stored presenter tracking camera position for the overview image of the stage. The
PresenterTrack feature will still work after the camera position has been cleared, but the camera
will not view a predefined position upon activation.
Requires user role: INTEGRATOR, USER
USAGE:
xCommand Cameras PresenterTrack ClearPosition
123
API Reference Guide
xStatus Appendices
CameraId
CameraId
Copyright © 2017 Cisco Systems, Inc. All rights reserved.