Xconfiguration Network [1] Qos Diffserv Data; Xconfiguration Network [1] Qos Diffserv Signalling - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80

Introduction

xConfiguration Network [1] QoS Diffserv Data

This setting will only take effect if Network QoS Mode is set to Diffserv.
Define which priority Data packets should have in the IP network.
The priority for the packets ranges from 0 to 63 - the higher the number, the higher the prior-
ity. The recommended value for Data is 0, which means best effort. If in doubt, contact your
network administrator.
The priority set here might be overridden when packets are leaving the network controlled by
the local network administrator.
Requires user role: ADMIN, USER
Default value: 0
USAGE:
xConfiguration Network n QoS Diffserv Data:
where
: Index that identifies the network. Range: 1..1
n
: Integer (0..63)
Data
Set the priority of the data packets in the IP network - the higher the number, the higher
the priority. The default value is 0 (best effort).
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API xConfiguration xConfiguration
Data
xCommand

xConfiguration Network [1] QoS Diffserv Signalling

This setting will only take effect if Network QoS Mode is set to Diffserv.
Define which priority Signalling packets that are deemed critical (time-sensitive) for the real-
time operation should have in the IP network.
The priority for the packets ranges from 0 to 63 - the higher the number, the higher the priority.
The recommended class for Signalling is CS3, which equals the decimal value 24. If in doubt,
contact your network administrator.
The priority set here might be overridden when packets are leaving the network controlled by
the local network administrator.
Requires user role: ADMIN, USER
Default value: 0
USAGE:
xConfiguration Network n QoS Diffserv Signalling:
where
: Index that identifies the network. Range: 1..1
n
: Integer (0..63)
Signalling
Set the priority of the signalling packets in the IP network - the higher the number, the
higher the priority. The default value is 0 (best effort).
62
API Reference Guide
xStatus Appendices
Signalling
Copyright © 2017 Cisco Systems, Inc. All rights reserved.