Xconfiguration H323 Nat Mode; Xconfiguration H323 Nat Address - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80

Introduction

xConfiguration H323 NAT Mode

The firewall traversal technology creates a secure path through the firewall barrier, and enables
proper exchange of audio/video data when connected to an external video conferencing
system (when the IP traffic goes through a NAT router). NOTE: NAT does not work in conjunc-
tion with gatekeepers.
Requires user role: ADMIN
Default value: Off
USAGE:
xConfiguration H323 NAT Mode: Mode
where
: Auto/Off/On
Mode
Auto: The system will determine if the H323 NAT Address or the real IP address should
be used in signaling. This makes it possible to place calls to endpoints on the LAN as
well as endpoints on the WAN. If the H323 NAT Address is wrong or not set, the real IP
address will be used.
Off: The system will signal the real IP address.
On: The system will signal the configured H323 NAT Address instead of its real IP
address in Q.931 and H.245. The NAT server address will be shown in the startup-
menu as: "My IP Address: 10.0.2.1". If the H323 NAT Address is wrong or not set, H.323
calls cannot be set up.
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API xConfiguration xConfiguration xCommand

xConfiguration H323 NAT Address

Define the external/global IP address to the router with NAT support. Packets sent to the
router will then be routed to the system. Note that NAT cannot be used when registered to a
gatekeeper.
In the router, the following ports must be routed to the system's IP address:
* Port 1720
* Port 5555-6555
* Port 2326-2487
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration H323 NAT Address: "Address"
where
: String (0, 64)
Address
A valid IPv4 address or IPv6 address.
54
API Reference Guide
xStatus Appendices
Copyright © 2017 Cisco Systems, Inc. All rights reserved.