Gpio Commands; Xcommand Gpio Manualstate Set; Httpfeedback Commands; Xcommand Httpfeedback Deregister - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80

Introduction

GPIO commands

xCommand GPIO ManualState Set

Set the state of a GPIO pin that is configured to OutputManualState mode (ref. xConfiguration
GPIO Pin [1..4] Mode).
Requires user role: ADMIN, USER
USAGE:
xCommand GPIO ManualState Set [Pin1: Pin1] [Pin2: Pin2] [Pin3: Pin3] [Pin4: Pin4]
where
: High/Low
Pin1
: High/Low
Pin2
: High/Low
Pin3
: High/Low
Pin4
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API xConfiguration xCommand xCommand

HttpFeedback commands

xCommand HttpFeedback Deregister

Deregister the HTTP feedback over HTTP(S).
Requires user role: ADMIN
USAGE:
xCommand HttpFeedback Deregister FeedbackSlot:
where
: Integer (1..4)
FeedbackSlot
Deregister the feedback slot that was registered using the xCommand HttpFeedback
Register command.
129
API Reference Guide
xStatus Appendices
FeedbackSlot
Copyright © 2017 Cisco Systems, Inc. All rights reserved.