Xconfiguration Conference Multistream Mode; Gpio Configuration; Xconfiguration Gpio Pin [1 - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80

Introduction

xConfiguration Conference MultiStream Mode

The video system supports multistream video for conferences.
Requires user role: ADMIN
Default value: Auto
USAGE:
xConfiguration Conference MultiStream Mode:
where
: Auto/Off
Mode
Auto: Multistream will be used when the conference infrastructure supports the feature.
Off: Multistream is disabled.
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API xConfiguration xConfiguration
Mode
xCommand

GPIO configuration

xConfiguration GPIO Pin [1..4] Mode
The four GPIO pins are configured individually. The state can be retrieved by xStatus GPIO Pin
[1..4] State. The default pin state is High (+12 V). When activated as an output, a pin is set to 0
V (Low); when deactivated, it is set to +12 V (High). To activate a pin as an input, the voltage on
the pin must be pulled down to 0 V; to deactivate it, raise the voltage to +12 V.
Requires user role: ADMIN, INTEGRATOR
Default value: InputNoAction
USAGE:
xConfiguration GPIO Pin n Mode:
where
: GPIO pin number. Range: 1..4
n
: InputAcceptAllCalls/InputDisconnectAllCalls/InputMuteMicrophones/InputNoAction/
Mode
OutputAllCallsEncrypted/OutputInCall/OutputManualState/OutputMicrophonesMuted/
OutputPresentationOn/OutputStandbyActive
InputAcceptAllCalls: When the pin is activated, the xCommand Call Accept command,
which accepts all incoming calls, will be issued.
InputDisconnectAllCalls: When the pin is activated, the xCommand Call Disconnect
command, which disconnects all calls, will be issued.
InputMuteMicrophones: When the pin is activated, the microphones will be muted.
When deactivated, the microphones will be unmuted.
InputNoAction: The pin state can be set, but no operation is performed.
OutputAllCallsEncrypted: The pin is activated when all calls are encrypted, and deacti-
vated when one or more calls are not encrypted.
OutputInCall: The pin is activated when in call, and deactivated when not in call.
OutputManualState: The pin state can be set by xCommand GPIO ManualState Set
PinX: <High/Low>. It is set to +12 V or 0 V, respectively.
OutputMicrophonesMuted: The pin is activated when microphones are muted, and
deacti¬vated when not muted.
OutputPresentationOn: The pin is activated when presentation is active, and deacti-
vated when presentation is not active.
OutputStandbyActive: The pin is activated when the system is in standby mode, and
deacti¬vated when no longer in standby.
51
API Reference Guide
xStatus Appendices
Mode
Copyright © 2017 Cisco Systems, Inc. All rights reserved.