Cisco TelePresence SX80 Reference Manual page 212

Cisco TelePresence SX80

Introduction
xStatus Video Output Connector [n] ConnectedDevice CEC PowerStatus
Shows the state of the CEC enabled devise connected to the HDMI output.
This information is only available when the device connected to the HDMI output has the
CEC feature configured on and the codec has the configuration xConfiguration Video Output
Connector CEC Mode set to on.
Requires user role: ADMIN, INTEGRATOR, USER
Value space of the result returned:
Unknown/Ok/In progress/Failed to power on/Failed to standby
Example:
xStatus Video Output Connector 1 ConnectedDevice CEC PowerStatus
*s Video Output Connector 1 ConnectedDevice CEC PowerStatus: Ok
** end
xStatus Video Output Connector [n] ConnectedDevice CEC VendorId
Returns the vendor ID for the connected device.
Requires user role: ADMIN, INTEGRATOR, USER
Value space of the result returned:
String
Example:
xStatus Video Output Connector 1 ConnectedDevice CEC VendorId
*s Video Output Connector 1 ConnectedDevice CEC 1 VendorId: "57489"
** end
xStatus Video Output Connector [n] ConnectedDevice Name
Shows the name of the monitor connected to the HDMI port as defined in the monitors EDID.
Requires user role: ADMIN, INTEGRATOR, USER
Value space of the result returned:
String
Example:
xStatus Video Output Connector 1 ConnectedDevice Name
*s Video Output Connector 1 ConnectedDevice Name: "G2420HDBL"
** end
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API xConfiguration xCommand
xStatus Video Output Connector [n] ConnectedDevice PreferredFormat
Shows the preferred input format of the monitor connected to the HDMI port as defined in the
monitors EDID. This is not necessarily the format the codec is sending out.
Requires user role: ADMIN, INTEGRATOR, USER
Value space of the result returned:
String
Example:
xStatus Video Output Connector 1 ConnectedDevice PreferredFormat
*s Video Output Connector 1 ConnectedDevice PreferredFormat: "1920x1080@60Hz"
** end
xStatus Video Output Connector [n] MonitorRole
Describes which video stream is shown on the device that is connected to the video output
connector.
First/Second/Third: The role of the monitor in a multimonitor setup. In a singlemonitor setup,
there is no difference between First, Second and Third.
PresentationOnly: Shows presentation video stream if active.
Recorder: Shows all participants, including the local main video. If active, shows also the
presentation.
Requires user role: ADMIN, USER
Value space of the result returned:
First/Second/Third/PresentationOnly/Recorder
Example:
xStatus Video Output Connector 1 MonitorRole
*s Video Output Connector 1 MonitorRole: First
** end
212
API Reference Guide
xStatus xStatus Appendices
Copyright © 2017 Cisco Systems, Inc. All rights reserved.