Cisco TelePresence SX80
Introduction
xCommand UserManagement User Passphrase Set
Set a user passphrase for the specified user. You must be logged in as an administrator to set a
user passphrase.
Requires user role: ADMIN
USAGE:
xCommand UserManagement User Passphrase Set NewPassphrase: "NewPassphrase"
Username: "Username" YourPassphrase: "YourPassphrase"
where
: String (0, 255)
NewPassphrase
: String (0, 127)
Username
: String (0, 255)
YourPassphrase
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API
xConfiguration
xCommand
xCommand
Video commands
xCommand Video ActiveSpeakerPIP Set
Sets position for the active speakers PiP (picture in picture).
Requires user role: ADMIN, USER
USAGE:
xCommand Video ActiveSpeakerPIP Set Position:
where
: CenterLeft/CenterRight/LowerLeft/LowerRight/UpperCenter/UpperLeft/
Position
UpperRight
Select one of the predefined positions.
xCommand Video Input SetMainVideoSource
Set which input source is the main video source. You can identify the source either by the
identifier of the connector that it is connected to; or by the identifier of the source itself.
This command requires the use of one, and only one, of these parameters: ConnectorId or
SourceId.
Requires user role: INTEGRATOR, USER
USAGE:
xCommand Video Input SetMainVideoSource [ConnectorId: ConnectorId] [SourceId:
SourceId]
where
: Integer (1..5)
ConnectorId
The identifier (ID) of the connector. Connector [n] has ID n. Run the following API
command to find the ID: xStatus Video Input Connector. The connector ID is also printed
on the codec connector panel.
: Integer (1..4)
SourceId
The identifier (ID) of the input source. Input Source [n] has ID n. Run the following API
command to find the ID: xStatus Video Input Source.
151
API Reference Guide
xStatus
Appendices
Position
Copyright © 2017 Cisco Systems, Inc. All rights reserved.