Xconfiguration Networkservices Ntp Server [1; Xconfiguration Networkservices Sip Mode; Xconfiguration Networkservices Snmp Mode; Xconfiguration Networkservices Snmp Host [1 - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80

Introduction
xConfiguration NetworkServices NTP Server [1..3] Address
The address of the NTP server that will be used when NetworkServices NTP Mode is set to
Manual, and when NetworkServices NTP Mode is set to Auto and no address is supplied by a
DHCP server.
Requires user role: ADMIN
Default value: 0.tandberg.pool.ntp.org
USAGE:
xConfiguration NetworkServices NTP Server
where
: Unique ID that identifies the NTP server. Range: 1..3
n
: String (0, 255)
Address
A valid IPv4 address, IPv6 address or DNS name.

xConfiguration NetworkServices SIP Mode

Define whether the system should be able to place and receive SIP calls or not.
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration NetworkServices SIP Mode:
where
: Off/On
Mode
Off: Disable the possibility to place and receive SIP calls.
On: Enable the possibility to place and receive SIP calls (default).
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API xConfiguration xConfiguration
n Address: "Address"
Mode
xCommand

xConfiguration NetworkServices SNMP Mode

SNMP (Simple Network Management Protocol) is used in network management systems to
monitor network-attached devices (routers, servers, switches, projectors, etc) for conditions
that warrant administrative attention. SNMP exposes management data in the form of variables
on the managed systems, which describe the system configuration. These variables can then
be queried (set to ReadOnly) and sometimes set (set to ReadWrite) by managing applications.
Requires user role: ADMIN
Default value: ReadOnly
USAGE:
xConfiguration NetworkServices SNMP Mode:
where
: Off/ReadOnly/ReadWrite
Mode
Off: Disable the SNMP network service.
ReadOnly: Enable the SNMP network service for queries only.
ReadWrite: Enable the SNMP network service for both queries and commands.
xConfiguration NetworkServices SNMP Host [1..3] Address
Define the address of up to three SNMP Managers.
The system's SNMP Agent (in the codec) responds to requests from SNMP Managers (a PC
program etc.), for example about system location and system contact. SNMP traps are not
supported.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration NetworkServices SNMP Host
where
: Identifies the SNMP host. Maximum three SNMP hosts are allowed. Range: 1..3
n
: String (0, 255)
Address
A valid IPv4 address, IPv6 address or DNS name.
67
API Reference Guide
xStatus Appendices
Mode
n Address: "Address"
Copyright © 2017 Cisco Systems, Inc. All rights reserved.