Xconfiguration Cameras Camera [1 - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80

Introduction
xConfiguration Cameras Camera [1..7] Brightness DefaultLevel
Define the brightness level. Requires the Cameras Camera [n] Brightness Mode to be set to
Manual.
Requires user role: ADMIN, INTEGRATOR
Default value: 20
USAGE:
xConfiguration Cameras Camera n
where
: Unique ID that identifies the camera. Range: 1..7
n
: Integer (1..31)
DefaultLevel
The brightness level.
xConfiguration Cameras Camera [1..7] Flip
With Flip mode (vertical flip) you can flip the image upside down. Flipping applies both to the
self-view and the video that is transmitted to the far end.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
USAGE:
xConfiguration Cameras Camera n
where
: Unique ID that identifies the camera. Range: 1..7
n
: Auto/Off/On
Flip
Auto: If the camera detects that it is mounted upside down, the image is automatically
flipped. If the camera cannot auto-detect whether it is mounted upside down or not, the
image is not changed.
Off: Display the image on screen the normal way.
On: Display the image flipped upside down. This setting is used when a camera is
mounted upside down, but cannot automatically detect which way it is mounted.
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API xConfiguration xConfiguration
Brightness DefaultLevel: DefaultLevel
Flip: Flip
xCommand
xConfiguration Cameras Camera [1..7] Focus Mode
Define the camera focus mode.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
USAGE:
xConfiguration Cameras Camera
where
: Unique ID that identifies the camera. Range: 1..7
n
: Auto/Manual
Mode
Auto: The camera will auto focus once a call is connected, as well as after moving the
camera (pan, tilt, zoom). The system will use auto focus only for a few seconds to set
the right focus; then auto focus is turned off to prevent continuous focus adjustments of
the camera.
Manual: Turn the autofocus off and adjust the camera focus manually.
xConfiguration Cameras Camera [1..7] Gamma Mode
This setting enables gamma corrections, and applies only to cameras which support gamma
mode. Gamma describes the nonlinear relationship between image pixels and monitor
brightness.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
USAGE:
xConfiguration Cameras Camera
where
: Unique ID that identifies the camera. Range: 1..7
n
: Auto/Manual
Mode
Auto: Auto is the default and the recommended setting.
Manual: In manual mode the gamma value is changed with the gamma level setting, ref.
Cameras Camera [n] Gamma Level.
44
API Reference Guide
xStatus Appendices
n Focus Mode: Mode
n Gamma Mode: Mode
Copyright © 2017 Cisco Systems, Inc. All rights reserved.