Defining Allowed Bandwidth In The Mcu; Selecting The Mcu Presentation Resolution - RADVision SCOPIA TIP Deployment Manual

Defining Allowed Bandwidth in the MCU

Make sure the bandwidth is configured to more than 1Mbps, which is the value required for
the Cisco telepresence. A value under 1Mbps causes the videoconference to disconnect.
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7

Selecting the MCU Presentation Resolution

Configure the MCU to allow presentation and video clips to be shared with the Cisco
telepresence components without quality loss.
The presentation video resolution must be reconfigured each time the service is changed.
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
Access the MCU administrator interface.
Select Configuration.
Select Conferences.
Locate the Services list section.
Select the Review button
Make sure that the required value is set to 1024 Kbps as a minimum in the list under Max call
rate (Kbps).
Figure 5-14
Select Apply.
Access the MCU administrator interface.
Select the icon.
Select Advanced parameters.
Select the Review button
Enter XGA as the format for video resolution, which equates to 1024x768.
next to the required service.
Adjusting the bandwidth
next to Presentation image size.
Configuring your SCOPIA Solution for Interoperability with Cisco Telepresence | 41