Verifying The Scopia Tip Gateway Installation - RADVision SCOPIA TIP Deployment Manual

Step 10
Step 11
Step 12
Note

Verifying the SCOPIA TIP Gateway Installation

After you installed the device and performed its initial configuration, you need to verify that
it is installed and configured correctly.
Procedure
Step 1
Step 2
Step 3
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
•
Subnet mask
If you are not using a subnet mask, press Enter.
•
Default router
Allow the unit to complete the reboot process. A new emulator session begins.
Close the terminal emulator session.
Connect a network cable to the left Ethernet connector on the rear side of the device (see
Figure 4-9 on page 20).
We recommend setting the network switch to 1Gbps Auto Negotiation full duplex, if
it can support this configuration. The throughput of the network switch should
always be the same as the setting in the MCU, whose default value is also 1Gbps.
You can change the default value from the MCU web administrator interface by
navigating to Configuration > Network > Port Settings.
On the front panel, verify that the power LED is lit green.
Figure 4-11
Verify that the status LED is lit green.
Check the network connection by verifying that the Ethernet activity LED is lit green.
Locating the front panel LEDs
Setting up the SCOPIA TIP Gateway | 22