Messages In The Cycles - Siemens SINUMERIK 840D Programming Manual

Error Messages and Error Handling
5

5.4 Messages in the cycles

5.4 Messages in the cycles
The cycles output messages in the dialog line of the
control. These messages do not interrupt
processing.
They provide information about specific cycle
behavior and how machining is progressing and are
usually displayed for the duration of the machining
operation or until the end of the cycle. The following
messages can be displayed:
Message text
"Depth: According to value for relative depth"
"Machining elongated hole"
"Machining slot"
"Machining circumferential slot"
"Wrong milling direction, G3 will be generated"
"Changed form of the undercut"
"First drilling depth according to FDPR"
"Attention final machining allowance ≥ tool diameter"
"Thread start <No.> - longitudinal thread machining"
"Thread start <No.> - face thread machining"
"Simulation active, no tool programmed, final
contour being traversed"
"Simulation active, no tool programmed, final
contour being traversed"
"Simulation active, no tool programmed"
In each case <No.> stands for the number of the
figure that is currently being machined.
5-288
Source
CYCLE81 ... CYCLE89, CYCLE840
LONGHOLE
SLOT1
SLOT2
SLOT1, SLOT2, POCKET1, POCKET2,
CYCLE90
CYCLE94, CYCLE96
CYCLE83
POCKET1, POCKET2
CYCLE97, CYCLE98
CYCLE97, CYCLE98
POCKET1...POCKET4,
SLOT1, SLOT2, CYCLE93,
CYCLE72
CYCLE72, POCKET1, ... POCKET4,
SLOT1, SLOT2, CYCLE93
CYCLE71, CYCLE90, CYCLE94, CYCLE96
SINUMERIK 840D/840Di810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
03.96
12.98
5
n
 Siemens AG 2000 All rights reserved.