Siemens SINUMERIK 840D Programming Manual page 286

Error Messages and Error Handling
5
5.3 Overview of cycle alarms
Alarm number
61115
61116
61117
61118
61124
61200
61211
61213
61215
61601
61602
61603
5-286
Alarm text
"Contour approach or
return mode (straight
line/circle/plane/
space) incorrectly
defined"
"Approach or return
travel=0"
"Active tool radius <=
0"
"Length or width = 0"
"Infeed width has not
been programmed"
"Too many elements in
machining block"
"No absolute reference" CYCLE76
"Circle radius too small" CYCLE77
"Blank dimension
incorrectly
programmed"
"Finished part
diameter too small"
"Tool width
incorrectly defined"
"Groove shape
incorrectly defined"
Source Explanation, remedy
CYCLE72 The contour approach or return mode
has been incorrectly programmed;
check parameter _AS1 or AS2.
CYCLE72 The approach or return travel is set to
zero and must be increased; check
parameter _LP1 or _LP2.
CYCLE71 The radius of the active tool is negative
POCKET3 or zero and must be altered.
POCKET4
CYCLE71 The length or width of the milling
surface is not permissible; check
parameters _LENG and _WID.
CYCLE71 A value for the infeed width _MIDA
must always be programmed for active
simulation without a tool.
CYCLE76
CYCLE77
CYCLE77
CYCLE76
CYCLE77
CYCLE94 A finished part diameter has been
CYCLE96 programmed
CYCLE93 Parting tool is larger than programmed
groove width
• Radii/chamfers on the groove base
CYCLE93
are not suitable for the groove width
• Face groove of a contour element
parallel to the longitudinal axis is not
possible
SINUMERIK 840D/840Di810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
03.96
04.00
5
 Siemens AG 2000 All rights reserved.