Row Of Holes - Holes1 - Siemens SINUMERIK 840D Programming Manual

03.96
2
2.3.2 Row of holes – HOLES1
Programming
HOLES1 (SPCA, SPCO, STA1, FDIS, DBH, NUM)
Parameters
SPCA
real
SPCO
real
STA1
real
FDIS
real
DBH
real
NUM
int
Function
With this cycle you can program a row of holes, i.e. a
number of holes that lie along a straight line or a grid
of holes. The type of hole is determined by the
drilling cycle that has already been called modally.
Sequence of operations
To avoid unnecessary travel, the cycle calculates
whether the row of holes is machined starting from
the first hole or the last hole from the actual position
of the plane axes and the geometry of the row of
holes. The drilling positions are then approached
one after the other in rapid traverse.
 Siemens AG 2000 All rights reserved.
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
Abscissa of a reference point on the straight line (absolute)
Ordinate of this reference point (absolute)
Angle to abscissa
Value range –180<STA1<=180 degrees
Distance between the first hole and the reference point (enter without
sign)
Distance between the holes (enter without sign)
Number of holes
Drilling Cycles and Drilling Patterns
2.3 Drill pattern cycles
2
2-93