Download  Print this page

Milling Rectangular Pockets - Pocket1 - Siemens SINUMERIK 840D Programming Manual

Hide thumbs

Advertisement

Milling Cycles
3

3.7 Milling rectangular pockets - POCKET1

3.7
Milling rectangular pockets - POCKET1
Programming
POCKET1 (RTP, RFP, SDIS, DP, DPR, LENG, WID, CRAD, CPA, CPD, STA1, FFD,
FFP1, MID, CDIR, FAL, VARI, MIDF, FFP2, SSF)
Parameters
RTP
real
RFP
real
SDIS
real
DP
real
DPR
real
LENG
real
WID
real
CRAD
real
CPA
real
CPO
real
STA1
real
FFD
real
FFP1
real
MID
real
CDIR
int
FAL
real
VARI
int
MIDF
real
FFP2
real
SSF
real
The cycle requires a milling cutter with an "end tooth
cutting over center" (DIN 844).
The pocket milling cycle POCKET3 can be performed
with any tool.
3-132
Retraction plane (absolute)
Reference plane (absolute)
Safety clearance (enter without sign)
Pocket depth (absolute)
Pocket depth relative to the reference plane (enter without sign)
Pocket length (enter without sign)
Pocket width (enter without sign)
Corner radius (enter without sign)
Pocket center point, abscissa (absolute)
Pocket center point, ordinate (absolute)
Angle between longitudinal axis and abscissa
Value range: 0<=STA1<180 degrees
Feedrate for depth infeed
Feedrate for surface machining
Maximum infeed depth for infeed (enter without sign)
Milling direction for machining the pocket
Value: 2 (for G2)
3 (for G3)
Final machining allowance on pocket edge (enter without sign)
Type of machining
Value: 0=Complete machining
1=Roughing
2=Finishing
Maximum infeed depth for finishing
Feedrate for finishing
Speed for finishing
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
03.96
08.97
3
 Siemens AG 2000 All rights reserved.

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments:
  • HARSHAL DHAWAS Aug 31, 2018 12:31:
    VERY USE FULL ARTICLE
    <a href="​;http://ww​w.hdknowle​dge.com&qu​ot;>
    Sinumerik 840D Drilling Cycle Program II CYCLE81II FOR MILLING </a>