Siemens SINUMERIK 840D Programming Manual page 31

12.97
1
These are then selected for input using the toggle
button.
(I/* 1 2 3 4 11 12 13 14/11/Selecting the
operating mode)[Operating mode / VARI]
In order to achieve compatibility with the states of
the cycle support for interactive programming of the
MMC 102/103, only the section in round brackets is
mandatory. The section in square brackets is
optional.
Explanation
If the section in square brackets is missing, proceed
as follows:
Short text=
Text in bitmap=
 Siemens AG 2000 All rights reserved.
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
1.4 Cycle support in program editor (SW 4.3 and later)
the first 19 characters of the long text but only up to the first blank from the
right or up to the first comma from the left.
Shortened texts are marked with an asterisk " * "
is read from the Cxx.awb file
General
1
1-31