Siemens SINUMERIK 840D Programming Manual page 68

Drilling Cycles and Drilling Patterns
2
2.1 Drilling cycles
Programming example
Rigid tapping
A thread is tapped without a compensating chuck at
position X30 and Y35 in the XY plane, the tapping
axis is the Z axis. No dwell time is programmed. The
depth is programmed as a relative value. The
parameters for the direction of rotation and the pitch
must be assigned values. A metric thread M5 is
tapped.
N10 G0 G90 T4 D4
N20 G17 X30 Y35 Z40
N30 CYCLE84 (40, 36, 2, , 30, , 3, 5, ->
->, 90, 200, 500)
N40 M30
-> Must be programmed in a single block
2-68
Y
30
Specification of technology values
Traverse to drilling position
Cycle call, parameter PIT has been
omitted, no value is entered for the
absolute depth or the dwell time. Spindle
stop at 90 degrees, speed for tapping is
200, speed for retraction is 500
End of program
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
03.96
08.97
2
Y
A - B
A
B
X
6
36
 Siemens AG 2000 All rights reserved.
Z